Wiring Your Pellet Unit

The pu-cb93 analog control board's wire connections are located in a vertical row on the left side of the printed circuit board.

Listed from the top of the board , the following sequence should be followed.

Note:

White wires are "common" if applicable , if there are two black wires either can be connected to common.

Colors shown below denote line color in chart above not actual wire colors.

1. Common for exhaust blower

2. Hot for exhaust blower

3. Common for top auger motor

4. Hot for top auger motor

5. Common for bottom auger motor

6. Hot for bottom auger motor

7. Common for room air blower 1

8. Hot for room air blower 1

9. Common for room air blower 2

10.Hot for room air blower 2

11. Common for the power cord

12. Hot for power cord

PU-CB93 Wiring Chart


Click on picture to enlarge

Note:

The thermostat connection is located at the bottom right corner of the control board.

 
Click on picture to enlarge

If you have any further questions or concerns, please contact Customer Service at:
1-800-245-6489

Copyright © 2005   England's Stove Works, Inc.   All rights reserved.
Revised:  11/07/2008

This web site, including all pictures, description and information of any sort contained therein is intended for the sole use of customers and representatives of England's Stove Works, Inc. No part of this web site or the information contained therein may be reproduced without express written permission from England's Stove Works, Inc..